Posted by Dan on Monday, 26 June 2006, at 9:34 p.m.:
In Reply to: leclerc spinning wheel flyer question posted by bigfatcats4 on Wednesday, 7 June 2006, at 9:21 a.m.:
I did some repair work recently on a Leclerc wheel that was similar to yours. The leather on the pulley end should have a smaller hole to match the shaft diameter. Also, the spool is mounted end for end on the flyer in the photos you provided. The spool's pulley needs to be next to the flyer's pulley so that one band of the double drive band can pass over it.